Creating Margins When Copying (Margin Shift) - Sharp AR-M162 Operation Manual

CREATING MARGINS WHEN COPYING
The margin shift function shifts the image to create a margin at the edge of the paper. By default the function creates
a 1/2" (10 mm) margin at the left edge of the paper.
• You can select whether to create a margin at the top edge or at the left edge of the paper.
• Five selections are available for the margin width: 0", 1/4", 1/2", 3/4", 1" (0 mm, 5 mm, 10 mm, 15 mm, 20 mm).
(The default setting is 1/2" (10 mm).)
• When making two-sided copies, a margin is created at the selected edge on the front side of the paper, and a
margin is created on the back side of the paper.
• Margin shift cannot be used in combination with 2 in 1 / 4 in 1 copy (page 66).
• Margin shift cannot be used in combination with card shot (page 71).
• When margin shift is selected, rotating copying will not operate even if the condition for rotate copying is met.
• The default margin shift setting can be changed in the key operator programs. (See the "Key operator's guide".)
1
Place the original in the document
feeder tray or on the document glass.
• When a left-edge margin is
selected and you are copying
from the document feeder
tray, place the original face up
so that the margin edge is to
the left.
When a left-edge margin is selected and you are
copying from the document glass, set the original
face down so that the margin edge is to the right.
• When a top-edge margin is selected, place the
original with the margin edge toward the rear of the
document feeder tray or the document glass.
2
Press the [SPECIAL FUNCTION] key.
DUPLEX
SPECIAL FUNCTION
DUPLEX SCAN
DUPLEX SCAN
ACC.
The function screen appears with "SPECIAL MODES"
selected.
3
Press the [OK] key.
BACK OK
GHI
The special modes screen will appear with "MARGIN
SHIFT" selected.
68
Margin (top)
A A
Original Copy
SPECIAL FUNCTION
SPECIAL MODES
ORIG. SIZE ENTER
PAPER SIZE SET
DISPLAY CONTRAST
SPECIAL MODES
MARGIN SHIFT
ERASE
DUAL PAGE COPY
[OK]:ADJUST
Margin (left edge)
A A
Original Copy
4
Press the [OK] key.
OK
The settings for margin
shift will appear.
5
Select the margin location with the
[ ] or [ ] key and select the width
with the [ ] or [ ] key.
• Select "DOWN" or "RIGHT"
GH
for the margin location.
• If you select 0" (0 mm), the
PQR
printed result is the same as
DUPLEX
when "OFF" is selected.
SPECIAL FUNCTION
DUPLEX SCAN
6
Press the [OK] key.
You will return to the base
OK
screen.
7
Select other copy settings as needed
and press the [START] key (
WXYZ
To turn off the margin shift
function, select the margin shift
@.- _
feature again and select "OFF".
READ-END
(Margin shift)
MARGIN SHIFT
OFF
DOWN
RIGHT
1/2 inch (0~1)
).