Scan; Scanning Overview - Sharp AR-M162 Operation Manual

3

SCAN

This chapter explains how to scan from a computer connected to the machine by a USB cable, and how to scan
using the machine's operation panel.
When the dual function board is installed
Note
Before using the machine in USB 2.0 High-speed mode, be sure to read "USB2.0 MODE" and "System
requirements for USB 2.0 (Hi-Speed mode)" in the "Key operator's guide".

SCANNING OVERVIEW

The flow chart shown below provides an overview of scanning.
The environment in which the machine's scanning function can be used is subject to certain limitations. For more
Caution
information, see "1. INSTALLING THE SOFTWARE (THAT ACCOMPANIES THE MACHINE)" in the "Software
setup guide".
Scanning from a
1
TWAIN* -compliant or
2
WIA* -compliant application
☞For more information, see "4. COPY FUNCTIONS" in the "Operation manual (for general information and copier)".
Start up a Twain-compliant
or WIA-compliant
application, and select the
machine's scanner driver.
Scanning
☞SCANNING FROM A
TWAIN-COMPLIANT
APPLICATION (page
SCANNING FROM A
WIA-COMPLIANT APPLICATION
(WINDOWS XP) (page 20)
*1 TWAIN is an international interface standard for scanners and other image acquisition devices. By installing a TWAIN driver on
your computer, you can scan and work with images using a variety of TWAIN-compliant applications.
*2 WIA (Windows Imaging Acquisition) is a Windows function that allows a scanner, digital camera or other imaging device to
communicate with an image processing application. The WIA driver for this machine can only be used in Windows XP.
*3 To begin scanning using the machine's operation panel, settings must be configured in the Control Panel after Button Manager
is installed. For more information, see "SETTING UP BUTTON MANAGER" in "1. INSTALLING THE SOFTWARE (THAT
ACCOMPANIES THE MACHINE)" in the "Software setup guide".
Scanning from the "Scanner
and Camera Wizard"
(Windows XP)
Place the original in the scanning position
Start up the "Scanner and
Camera Wizard" from
"Control Panel" in your
computer.
Set the scan preferences
☞SCANNING FROM THE
"SCANNER AND CAMERA
16),
WIZARD" (WINDOWS XP)
(page 21)
Scanning
Using the machine to begin
*3
scanning
Press the [SCAN] key on the
machine to switch to
scanner mode and select the
destination (SC1: to SC6:)
Scanning
☞SCANNING USING THE
KEYS ON THE MACHINE
(page 23),
BUTTON MANAGER (page 24)
15