System Information Stacking Hardware Monitor - ZyXEL Communications XS3800-28 User Manual

Table 14 Basic Setting > System Info (continued)
L ABEL
FAN Speed
(RPM)
Current
MAX
MIN
Threshold
Status
Voltage(V)
Current
MAX
MIN
Threshold
Status
Power Source
Status
Hardware Status (Stacking Mode)
Slot
Name
Voltage
Temperature
Fan
Power Source
8.2.1 Syste m Info rm a tio n Sta c king Ha rdwa re Mo nito r
Click a slot number in the
a Switch.
Chapter 8 Basic Setting
DESC RIPT IO N
A properly functioning fan is an essential component (along with a sufficiently ventilated, cool
operating environment) in order for the device to stay within the temperature threshold. Each
fan has a sensor that is capable of detecting and reporting if the fan speed falls below the
threshold shown.
This field displays this fan's current speed in Revolutions Per Minute (RPM).
This field displays this fan's maximum speed measured in Revolutions Per Minute (RPM).
This field displays this fan's minimum speed measured in Revolutions Per Minute (RPM). "<41" is
displayed for speeds too small to measure (under 2000 RPM).
This field displays the minimum speed at which a normal fan should work.
indicates that this fan is functioning above the minimum speed.
No rm a l
fan is functioning below the minimum speed.
The power supply for each voltage has a sensor that is capable of detecting and reporting if the
voltage falls out of the tolerance range.
This is the current voltage reading.
This field displays the maximum voltage measured at this point.
This field displays the minimum voltage measured at this point.
This field displays the percentage tolerance of the voltage with which the Switch still works.
indicates that the voltage is within an acceptable operating range at this point;
No rm a l
otherwise is displayed.
Erro r
This field lists the power supply modules installed in the Switch.
indicates the Switch is currently operating from the power source to which the power
Ac tive
module is connected.
indicates the power module is connected to a power source but the Switch is NOT
Sta ndb y
operating from it.
is displayed when the power module is not connected to a power source and there is no
N/ A
available power.
This number identifies the Switch in the stack. Click the number to see more detailed information
on the Switch.
This is the system name of the Switch in the stack.
This shows if the power supply voltage sensor is within normal tolerance range.
This shows if the temperature sensors on the Switch printed circuit board are within normal
tolerance range.
This shows if the fan sensors are within normal tolerance range.
This shows if the Switch is properly operating from the connected power source.
rmation screen to display more detailed hardware information on
Syste m Info
XS3800-28 User's Guide
90
indicates that this
Erro r
is , and is
PSU_1 PWR1 PSU_2
.
PWR2