Connecting To A Computer (Digital And Analog Rgb) - Sanyo PLC WTC500AL Owner's Manual

Installation

Connecting to a Computer (Digital and Analog RGB)

Cables used for connection
• VGA Cable (Mini D-sub 15 pin) (One cable is supplied)*
• HDMI-DVI Cable *
• BNC Cable *
USB port
USB
cable
USB
✔Notes:
• USB cable connection is needed when operating the
computer with the remote control.
• When the Standby mode is set to "Eco" in the Setting,
MONITOR OUT and AUDIO OUT are disabled. (p.56)
Unplug the power cords of both the projector and external
equipment from the AC outlet
20
*
)( =Cables are not supplied with this projector.)
• Serial Control Cable *
• USB Cable *
DVI
Output
Monitor Output
BNC HDMI-DVI
cable cable
G B R H/V V HDMI
before connecting cables.
Monitor
Monitor
Input
Output
Serial
VGA VGA
Control
cable cable
Cable
MONITOR
ANALOG
OUT
IN
✔Notes:
• When DVI signal is connected to HDMI
terminal with HDMI-DVI cable, connect the
sound signal to AUDIO1 and set up Sound of
"HDMI setup" to "AUDIO1". (p.58)
•This projector can be connected to the
corresponding equipment of DVI however
depending on the equipment there are the
cases it does not operate normally ; the image
does not appear and the sound is not output.
Serial
Output
CONTROL
PORT