Connecting Ac Power Cord; Connecting To Computer (Digital And Analog Rgb); Remote Control Battery Installation - Sanyo PLC-XF60A Quick Reference Manual

Connecting AC Power Cord

This projector uses nominal input voltages of 120 V or
200-240 V AC and it automatically selects correct input
voltage. It is designed to work with the single-phase
power systems having a grounded neutral conductor. To
reduce risk of electrical shock, do not plug into any other
type of power system.
If you are not sure of type of the power being supplied,
consult your authorized dealer or service station.
Connect the projector with all peripheral equipment before
turning it on.
CAUTION
For safety, unplug the AC power cord when the
projector is not in use. When the projector is connected
to an outlet with the AC power cord and the Main
On/Off switch is on, it is in stand-by mode and
consumes a little electric power.
NOTE ON POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and a proper AC power cord must be used.
If the supplied AC Power Cord does not match your AC outlet, contact your sales dealer.
Projector side
For the U.S.A. and Canada
Ground
To POWER CORD
CONNECTOR on the
To the AC Outlet.
projector.
(120 V AC)

Remote Control Battery Installation

Open the battery Install new batteries
1 2
compartment lid. into the compartment.
Press the lid downward
and slide it.
Main On/Off switch
AC power socket
Connect the AC power cord (supplied)
to this socket. The AC outlet must be
near this equipment and must be easily
accessible.
AC Outlet side
For Continental Europe For the U.K.
To the AC Outlet. To the AC Outlet.
(200 - 240 V AC) (200 - 240 V AC)
Replace the compartment
3
lid.
Two AA size alkaline
batteries
For correct polarity (+
and –), be sure battery
terminals are in
contact with pins in
the compartment.
English

Connecting to Computer (Digital and Analog RGB)

Cables used for connection
q VGA Cable (HDB 15 pin) (Only one cable is supplied.)
w DVI-D Cable ✽
e BNC Cable ✽
r Serial Cross Cable (RS-232C) ✽
✽
( = Not supplied with this projector.)
PC Serial Port Monitor Output Monitor Output
r ✽ w ✽
ANALOG IN
DIGITAL (DVI-D)
SERIAL PORT IN
Note:
Unplug the power cords of both the projector and external
equipment from the AC outlet before connecting the cables.
Monitor Input Monitor Output
q q e ✽
ANALOG OUT R G B H/V V
Other Projector
SERIAL PORT OUT
SERIAL PORT IN
r ✽