Remote Control Battery Installation; Remote Control Receivers And Operating Range; Wired Remote Control - Sanyo PLC WTC500AL Owner's Manual

Part Names and Functions

Remote Control Battery Installation

Open the battery
1
compartment lid.
Press the lid
downward and slide it.
To ensure safe operation, please observe the following precautions :
l Use two (2) AAA or LR03 type alkaline batteries.
l Always replace batteries in sets.
l Do not use a new battery with a used battery.
l Avoid contact with water or liquid.
l Do not expose the remote control to moisture or heat.
l Do not drop the remote control.
l If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.
l Risk of an explosion if battery is replaced by an incorrect type.
l Dispose of used batteries according to the instructions.

Remote Control Receivers and Operating Range

Point the remote control toward the projector (to Infrared
Remote Receivers) when pressing the buttons. Maximum
operating range for the remote control is about 16.4' (5 m)
and 60 degrees in front and rear of the projector.
Infrared Remote Receivers are provided both in front and
back of the projector. You can conveniently use both of the
receivers (see pages 10, 55).
✔Notes:
• When hanging the projector from the ceiling, select the
Infrared Remote Receiver which is located farther away
from the fluorescent light (p.55).
• When using the projector in the horizontal position
without hanging from the ceiling, it is recommended to
deactivate the top Infrared Remote Receiver to avoid the
effects of the fluorescent light (p.55).

Wired Remote Control

The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside
of the operating range (16.4'/ 5 m). Connect the remote control and the projector with the remote control cable (sold
separately). Connected with the remote control cable, the remote control does not emit wireless signal.
16
Install new batteries
2
into the compartment.
Two AAA size batteries
For correct polarity (+ and –),
be sure battery terminals are
in contact with pins in the
compartment.
Replace the
3
compartment lid.
16.4'
(5 m)
16.4'
(5 m)