Samson 3730 Series Mounting And Operating Instructions page 197

Code Parameter – Readings/
no.
values [default setting]
39 Set point deviation e info
–99.9 to 99.9 %
40 Transit time Open info
[0] to 240 s
41 Transit time Closed info
[0] to 240 s
42 Auto-w info
0.0 to 100.0 % of the
span
43 Firmware info
44 y info
[0] to 100 %, 0P, MAX,
– – –
45 Solenoid valve info
YES, HIGH/LOW, No
46* Polling address
[0] to 63, ESC
47* Write protection HART
YES, [No], ESC
48*
Diagnostic parameters u EB 8389
49*
EB 8384-3 EN
Description
Read only
Indicates the deviation from the target position (e = w – x).
Read only
Minimum opening time determined during initialization.
Read only
Minimum closing time determined during initialization.
Read only
Indicates the applied automatic set point with corresponding 4 to
20 mA signal.
Read only
Indicates the positioner type and current firmware version in alter-
nating sequence.
Read only
Indicates the control signal y in % in relation to the travel range de-
termined during initialization.
MAX: The positioner builds up its maximum output pressure,
see description in Code 14 and 15.
0P: The positioner vents completely, see description in Code
14 and 15.
– – –: The positioner is not initialized.
Read only
Indicates whether a solenoid valve is installed or not.
If a voltage supply is connected at the terminals of the installed sole-
noid valve, YES and HIGH appear on the display in alternating se-
quence. If a voltage supply is not connected (actuator vented, fail-
safe position indicated on the display by the S icon), YES and LOW
appear on the display in alternating sequence.
Select bus address
When write protection is active, device data can be read, but not
®
overwritten over HART communication.
®
16-9