Table of Contents
Advertisement
The LIST or SWEEP Subsystem command group sets the List Sweep
measurement function, including the sweep point setting and limit values for
the limit function.
The LIST:PARAmeter command sets the list sweep parameter.
The LIST:STAT command turns on/off the specified sweep point.
1.800.561.8187
LIS T
Command
LIST:PARAmeter {FREQ,VOLT,CURR}
Syntax
Parameter
Where, {FREQ,LEVEL} is:
FREQ
VOLT
CURR
Example
SEND> LIST:PARA VOLT<NL>
Query Syntax
LIST:PARAmeter?
Query Response
{FREQ,VOLT,CURR}
Example
SEND> LIST:PARA?<NL>
RET>
Command
LIST:STAT <n>,{ON,OFF,1,0}
Syntax
Parameter
Where,<n> is:
n
ON or 1 Set this point to ON
OFF or 0 Set this point to OFF
Example
SEND> LIST:STAT 1,ON<NL>
Query Syntax
LIST:STAT? <n>
www.
:PARAmeter
{FREQ,VOLT,CURR}
:S TAT
<n>,{ON,OFF}
:BAND
<n>,<value>,{A,B,OFF},<low>,<high>
Sets the sweep parameter to frequency
Sets the sweep parameter to voltage level
Sets the sweep parameter to current level
FREQ<NL>
NR1(1 to 10): List sweep point
.com
T3LCR Series User Manual
117
information@itm.com
Advertisement
Table of Contents
