Teledyne LeCroy certifies compliance to the following standards as of the
time of publication. Please see the EC Declaration of Conformity document
shipped with your product for current certifications.
The instrument meets intent of EC Directive 2014/30/EU for
Electromagnetic Compatibility. Compliance was demonstrated to the
following specifications listed in the Official Journal of the European
Communities:
EN 61326-1:2013, EN 61326-2-1:2013 EMC requirements for electrical
equipment for measurement, control, and laboratory use.
EN 55011:2016+A1:2017, Radiated and Conducted Emissions Group 1, Class
A
EN 61000-3-2:2014 Harmonic Current Emissions, Class A
EN 61000-3-3:2013 Voltage Fluctuations and Flickers, Pst = 1
EN 61000-4-2:2009 Electrostatic Discharge, 4 kV contact, 8 kV air, 4 kV
vertical/horizontal coupling planes
EN 61000-4-3:2006+ A2:2010 RF Radiated Electromagnetic Field,
3 V/m, 80-1000 MHz; 3 V/m, 1400 MHz-2 GHz; 1 V/m, 2 GHz-2.7 GHz
EN 61000-4-4:2012 Electrical Fast Transient/Burst, 1 kV on power supply
lines, 0.5 kV on I/O signal data and control lines
EN 61000-4-5:2014+A1:2017 Power Line Surge, 1 kV AC Mains, L-N, L-PE,
N-PE
EN 61000-4-6:2014 RF Conducted Electromagnetic Field, 3 Vrms, 0.15 MHz
- 80 MHz
EN 61000-4-11:2004+A1:2017 Mains Dips and Interruptions, 0%/1 cycle,
70%/25 cycles, 0%/250 cycles
*1
*2
*3
1.800.561.8187
*2*3
*4
To ensure compliance with all applicable EMC standards, use high-quality shielded interface
cables.
Emissions which exceed the levels required by this standard may occur when the instrument
is connected to a test object.
This product is intended for use in nonresidential areas only. Use in residential areas may
www.
*4
*4
*4*5
.com
T3LCR Series User Manual
*1
141
information@itm.com