Warning/Status Display Section; Display Window And Its Displays - Panasonic AJ AJ-HDX900 Operating Instructions Manual

Chapter 2 Parts and their functions

2-6 Warning/status display section

5
1 Back tally lamp
When the back tally switch 2 is set to ON, this lamp
serves the same function as the front tally lamp in the
viewfinder.
2 Back tally switch
This is used to control the unit's back tally lamp 1 and
rear tally lamp 6.
ON : The back tally lamp and rear tally lamp operate.
OFF : The back tally lamp and rear tally lamp do not
operate.
3 WARNING lamp
When a problem of some form or other occurs within the
VTR unit, this lamp flashes or lights.
4 LIGHT switch
This controls the lighting of the display window.
Each time it is pressed, the lighting of the display window
5 is set in turn from on to off or vice versa.
5 Display window
This displays the alarms, remaining battery charge, audio
levels, time data, etc. relating to the VTR unit.
6 Rear TALLY lamp
When the back tally switch 2 is set to ON, this lamp
operates in exactly the same way as the back tally lamp.
(continued)

2-7 Display window and its displays

Remaining tape and remaining battery charge and
audio channel level displays
1
Remaining tape display
2
The remaining tape time is displayed using 7 segments.
The remaining tape time indicated by each segment is set to 3 minutes or 5
minutes using TAPE REMAIN/∫ on the VTR MENU "BATTERY/TAPE"
4
screen. Each time the number of minutes set for the segments elapses, one
segment is cleared.
3
NDF
CTL
h
TAPE
BATT
RF SERVO HUMID SLACK
6
Remaining battery charge display
If a battery with a digital display (% display) is used, all 7 segments
up to the "F" position light when the 70% or more of the battery
charge remains.
When there is less than 70% of the battery charge remaining, the
segments go out one by one in sequence every time the remaining
charge drops by 10%. It is also possible to set all 7 segments to light
at a 100% battery charge by selecting 100% as the setting for BATT
REMAIN FULL on the <BATTERY/TAPE> screen of the VTR menu.
Audio channel level meter
When the MONITOR SELECT CH1/2OCH3/4 switch is set to
CH1/2, numbers 1 and 2 indicating the audio channels appear, and
the CH1 and CH2 audio levels are displayed. Conversely, when it
is set to CH3/4, numbers 3 and 4 indicating the audio channels
appear, and the CH3 and CH4 audio levels are displayed.
Displays relating to the VTR unit's operations and
modes
Error code display
(for details, refer to "6-3 Warning system")
NDF
CTL
h
TAPE
BATT
RF SERVO HUMID SLACK
Warning displays
RF: Clogged video head
SERVO: Servo disturbance
HUMID: Formation of condensation on the head drum
SLACK: Problem in tape take-up
For details, refer to "6-3 Warning system."
SLAVE HOLD GPS
OVER
VTCG TIME DATE P-iREC
Y minM s D frm
E B
E F
13
SLAVE HOLD GPS
OVER
VTCG TIME DATE P-iREC
Y minM s D frm
E B
E F
13
2
OVER
0
10
20
30
40
OO
24
-dB
OVER
0
10
20
30
40
OO
24
-dB
19