When Using An Audio Component; Mounting The Unit On A Tripod - Panasonic AJ AJ-HDX900 Operating Instructions Manual

Chapter 5 Preparation

5-4-3 When using an audio component

1
Connect the AUDIO IN connectors on the camera with
the audio component using the XLR cable.
2
Set the AUDIO IN switch or switches for the channel or
channels to which the audio component has been
connected to "REAR."
3
Set the LINE/MIC/+48V selector switch on the rear panel
to "LINE."
AUDIO IN switches
(continued)

5-5 Mounting the unit on a tripod

Use the tripod adapter (SHAN-TM700) to mount the unit on a
tripod.
1
<Note>
Take account of the center of gravity of the unit and that of
the tripod adapter when selecting the adapter hole. Check
LINE/MIC/+48V
that the diameter of the hole selected matches the diameter
selector switch
of the tripod head screw.
2
AUDIO IN connectors
Slide the unit along the groove toward the front until it clicks
into place.
Detaching the unit from the tripod adapter
While pushing down the red lever, move the black lever in
the direction of the arrow and slide the unit toward the back
to remove it.
<Note>
If the pin of the tripod adapter fails to return to its original
position after the unit has been detached, again move the
black lever in the direction of the arrow while pushing down
the red lever, and return the pin to its original position. Bear
in mind that the unit cannot be attached if the pin remains in
the center.
Mount the tripod adapter on the tripod.
Tripod adapter
Mount the unit on the tripod adapter.
Tripod adapter
Red lever
Tripod head
Black lever
87
5