Spray - Graco Reactor 3 E-20 Standard Operation

Operation

Spray

Spray Spray
1. Engage the gun piston safety lock and close
gun fluid inlet valves A and B.
Fusion Fusion Fusion
2. Attach the gun fluid manifold. Connect the
gun air line. Open the air line valve.
3. Adjust the gun air regulator to desired gun
air pressure. Do not exceed the maximum
rated air pressure. See your gun manual,
Related Manuals, page 3
4. Set the pressure relief/spray valves (SA, SB)
to spray .
5. Verify the heat zones are on and
temperatures are on target.
40
Probler Probler Probler
.
6. Open the fluid inlet valve located at each
pump inlet.
Pump Mode Mode button
7. Tap the Pump Pump Mode
Spray mode from the drop down
8. Select Spray Spray
menu.
9. If If If using using pneumatic using pneumatic pneumatic transfer
air to the transfer pumps. See your pump
manual, Related Manuals, page 3
10. Tap to turn on the motor.
NOTE: Electric transfer pumps will
NOTE: NOTE:
automatically turn on with the motor.
11. Check the fluid pressure gauges (GA, GB)
to ensure proper pressure balance. If
imbalanced, reduce pressure of higher
component by slightly turning the pressure
relief/spray valve for that component toward
pressure relief/circulation
gauges show balanced pressures.
SA
.
transfer pumps, transfer pumps, turn on pumps,
.
until the
SB
3A8500B