Table of Contents
Advertisement
Calibration
Calibration
Calibration
Calibrate
Calibrate
Calibrate the
the Heated
the
Heated Hose
Heated
NOTICE
NOTICE
NOTICE
To prevent damage to the heated hose, a hose
calibration is required if any of the following
conditions are true:
• The hose has never been calibrated before.
• A section of hose has been replaced.
• A section of hose has been added.
• A section of hose has been removed.
NOTE: The Reactor and heated hose must be at
NOTE:
NOTE:
the same ambient temperature to get the most
accurate calibration.
NOTE:
NOTE:
NOTE:
A minimum of 50 ft (15.2 m) hose is required
for proper operation while in Resistance Control
Mode.
1. Tap
. Go to Setup
Setup > Heat
Setup
2.
Tap Calibrate
Calibrate
Calibrate
3. Tap Continue
Continue
Continue
the reminder to have the hose at ambient
conditions.
4. Wait while the system measures the hose
resistance.
NOTE:
NOTE: If hose heat was on prior to the
NOTE:
calibration procedure, the system will
wait up to five minutes to allow the wire
temperature to equalize.
5. Tap Accept
Accept
Accept
calibration, or Cancel
Cancel
Cancel
calibration.
NOTE:
NOTE:
NOTE: A temperature estimate will be
displayed if the system was able to measure
the hose wire resistance.
3A8500B
Hose
Hose
Heat.
Heat
.
to acknowledge
to proceed with the
to stop the
Calibrate the
Calibrate
Calibrate
the
the Transfer
Transfer Pumps
Transfer
After installing a new electric transfer pump,
you must calibrate the transfer pump motor.
1. Tap
. Go to Setup
Setup > Supply
Setup
2. If the transfer pump type is set to Electric
change the transfer pump type to Air
the Transfer
Transfer Pump
Transfer
Pump
Pump (A (A (A or or or B) B) B) Type
Air.
Air
Air
3. Change the transfer pump type from Air
Electric
Electric
Electric. Tap the Transfer
Transfer Pump
Transfer
Electric.
field. Select Electric
Electric
NOTE:
NOTE:
NOTE: Changing the transfer pump type
from Air
Air to Electric
Air
Electric triggers the calibration
Electric
function.
4. If If If calibrating
calibrating both
calibrating
both transfer
both
steps 2–3 for the other transfer pump motor.
5. Confirm there is no or low inlet pressure
in the transfer pump by opening the
recirculation lines (R).
6. Turn on the transfer pumps. The transfer
pumps will slowly move for multiple strokes
and then shift into normal operation.
a. To turn on the transfer pumps
individually: Tap
on the A-side transfer pump or tap
to turn on the B-side transfer
pump.
b. To turn on both transfer pumps with
the system: Tap
the motor. Electric transfer pumps will
automatically turn on with the motor.
Operation
Pumps
Pumps
Supply System
Supply
System
System.
Electric,
Electric
Air. Tap
Air
Type
Type field. Select
Air to
Air
Pump (A (A (A or or or B) B) B) Type
Pump
transfer pumps,
transfer
pumps, repeat
pumps,
to turn
to turn on
Type
Type
39
Advertisement
Table of Contents
