Diagnostic Screen - Graco Reactor 3 E-20 Standard Operation

Advance Display Module (ADM)
Proportioner Proportioner Control Proportioner Control Panel Control
This Proportioner Control panel contains
controls for operation of the proportioner pump.
Icon Name
Icon Icon Name Name
Propor-
tioner Pump
Pressure
Setpoint
Propor-
tioner Pump
Jog Level
Propor-
tioner Pump
Modes
Propor-
tioner Pump
On/Off
46
Panel Panel
Description
Description Description
Tap +/– to adjust the
setpoint by ten psi. Press
and hold +/– to slew.
Tap the number to open
pop-up and type in
setpoint directly.
Tap +/– to adjust the
jog level by one. Press
and hold +/- to slew.
Tap the number to open
pop-up and type in jog
level directly.
Tap to select the
proportioner pump mode.
Spray Spray : : : used to pressurize Spray
and spray material. Pump
drives to pressure setpoint.
Jog: Jog: Jog: used to
recirculate/flush material.
Pump drives to jog level.
Park: used to park the
Park: Park:
electric transfer pumps
and proportioner pump.
Parking is done to
increase seal life on
the proportioner pump
and ease ProConnect for
the electric tranfer pumps
(if present).
NOTE: The park operation
NOTE: NOTE:
will start when entering
Park mode from any other
mode. The park icon
will flash red while park
operation is in progress.
Parked: indicates a park
Parked: Parked:
operation has completed
successfully.
Tap to toggle the
proportioner pump state.

Diagnostic Screen

Diagnostic Diagnostic Screen Screen
Use the Diagnostic screen to view information
for all system components.
Icon Icon Icon Name Name Name
General
System Data
Heat Data
Pressure /
Flow Data
Override ISO
Lube Pump
Electric
Transfer
Pump Data
Engine Data
Description Description Description
Tap to display general
system information related to
heat/pressure/flow.
Tap to display more detailed
information related to heat.
Tap to display more detailed
information related to pressure
/ flow.
Press to force the ISO lube
pump to run.
NOTE: Button is momentary NOTE: NOTE:
(must press and hold to run
pump).
Tap to display more detailed
information related to electric
transfer pumps.
NOTE: This page is only
NOTE: NOTE:
displayed if at least one
electric transfer pump is
installed on the system.
Tap to display more detailed
information related to engine.
NOTE: NOTE: This page is only NOTE:
displayed if an active
connection is present between
the MCM port 13 and an engine
with a J1939 communication
port.
3A8500B