Table of Contents
Advertisement
6. With the help of a second person, tip the rower
to the upright position.
Remove and discard the two shipping screws (B)
and the shipping bracket (A).
7. Note: The Console (not shown) is
preattached to the Console Bracket (7).
For clarity, the Console is not shown in the
drawings in steps 7 and 8.
Tip: Avoid pinching the wires. Hold the
Neck (8) with the attached Console Bracket (7)
inside the bracket on the Frame (1). Attach the
Neck with an M10 x 40mm Screw (105); do not
fully tighten the Screw yet.
Finish attaching the Neck (8) with an
M10 x 65mm Screw (119). Then, fully tighten
the M10 x 40mm Screw (105).
Then, connect the Neck Wire (93) to the Main
Wire (92). Tip: The wire connectors should
slide together easily and snap into place
with an audible click. If they do not, turn one
connector and try again.
6
7
7
Avoid pinching
the wires
9
B
A
105
8
93
1
92
119
B
Advertisement
Table of Contents
