Table of Contents
Advertisement
Indoor unit
1. The air inlet and outlet should be far
away from the barrier to make sure that
the air can reach to all parts of the room;
2. Select the location where it is easy to
drain the condensing water and connect
to the outdoor unit;
3. Keep the indoor unit far away from the
heat source, vapor and inflammable gas;
4. Install in a location where is strong
enough to withstand the full weight and
vibration of the unit;
5. Be sure that the installation of the indoor
unit conforms to the installation dimension
diagram;
6. Be sure to leave enough space to allow
access of routine maintenance, clearance
between the indoor unit and the floor
should be more than 200cm;
7. Install in a location where is more than 1
meter away from other electric appliances
such as television, audio device etc.;
8. Select location where is easy to remove
and clean the air filters.
MCW - SVN13A - E4
Installation Location
Outdoor unit
1. Select a location from which noise and
air discharge by unit will not annoy
neighbors.
2. Select location where there should be
sufficient ventilation.
3. There should not be barriers preventing
air inlet and outlet near the outdoor unit.
4. Select the location which can bear the
weight and vibration of the outdoor unit,
where installation work can be carried
out safely.
5. There should be no danger of flammable
or corrosive gas leaks.
6. Be sure that the installation of the outdoor
unit conforms to the installation dimension
diagram.
CAUTION!
Install in the following place may cause mal-
function. If it is unavoidable, contact with
service agency for consultant.
Place where oil (machine oil) is used.
The place where a lot of salinities such
as coast exists.
Place where a sulfured gas such as the
hot spring zones is generated.
Place where high-frequency waves are
generated by radio equipment, welders
and medical equipment.
Other place with special circumstance.
7
Advertisement
Table of Contents
