. result in minor or moderate injury or manual. malfunction of the unit. Trane MCC series of fer ceiling For installing the unit to operate mounted installation to leave the floor Your personal safety and the pr oper...
Indoor Unit Installation • Hang the four mounting rods to the • Install the leveling metal plate to Where to install Indoor Unit positions marked as picture shown adjust the gap between the unit • There should not be any heat in figure 3 (using twelve nuts and and a ceiling, fixing the screws source or steam near the unit.
Outdoor Unit Installation Wher e to install Outdoor more than 10 cm. more than 10 cm. Unit • The foundation must be solid enough to bear the weight and more than 10 cm. vibration of the unit. • The space ar ound the unit is more than 35 cm.
Connection of Refrigerant Tubing and Condensate Drain Piping Connecting the unit with flaring A good flare should have the 10. Tighten the flare nut to the specified tightening torque with procedure following characteristics: torque wrench and adjustable 1. Flaring (If piping is procured or cut Inside surface is glossy and wrench.
Page 7
Leak Check and System Evacuation Leak Check 8. Close valve on the R-22 supply Procedure cylinder. Close valves on manifold After the connection operation of 1. Connect R-22 drum with gauge gauge set and remove refrigerant refrigerant lines to both the outdoor manifold to the Schrader valves charging hoses from liquid and and indoor unit is completed, the field...
Dimensional Data Model MCC518ZB MCC524ZB MCC530ZB MCC536ZB MCC048ZB A. Height above ceiling B. Height above suspension brackets C. Height of condensate drain above ceiling D. Pipe exit position refrigerant pipe drainpipe outlet main cable entry CEILING HOLES 860-890 MCC-SVN02A-EN...