Trane MWW509IB Installation Manual page 12

CAUTION!
All the electrical work must be done by
qualified personnel according to the local
rules and this manual.
The rated voltage and the exclusive circuit
must be used.
Leakage circuit - breaker must be
installed.
Please use specified fuse.
The diameter of power cord should be
large enough. Use the exclusive wire to
replace the damaged wire.
Wiring work should conform to national
standard.
12
Installation for
Install the indoor unit
1. When routing the piping or wiring from
the left or right side of the indoor unit,
cut off the tailings from the chassis in
necessary (Shown in figure 5)
(1) Cut access hole 1 when only routing
the power wire.
(2) Cut tailings 1 when routing both the
wiring and piping.
2. After wrapping the connetion tubes and
wire, put them through the wall piping
hole. (Figure 6)
3. Hang the grip at the back of the indoor
unit to the hook on the mounting plate,
check if it is firm enough.
Figure 4
MWW518IB/TWK518JB
MWW524IB/TWK524JB
4. The height of the installation location
should be more than 2.3m from the floor.
Figure 5
Figure 6
MCW - SVN13A - E4