Selecting The Installation Location; Specifications - Trane MITSUBISHI ELECTRIC NTXWMT09A111A Series Installation Manual

1-2. SELECTING THE INSTALLATION LOCATION

INDOOR UNIT
the affected device.
Note:
Install the indoor unit high on the wall where air can
REMOTE CONTROLLER
remote controller holder to a pillar or wall and install
wireless remote controller.

1-3. SPECIFICATIONS

1-3-1. POWER SUPPLY AND INDOOR/OUTDOOR
WIRE CONNECTION
Connecting wires and the ground wire
* Follow local electrical codes.
Power supply cable and ground wire
* Follow local electrical codes.
Note:
1-3-2. REFRIGERANT PIPES
CAUTION
to form.
sides.
the pipe.
units.
Note:
received.
OUTDOOR UNIT
-
or hot (or cool) air.
device.
Electrical speci cations
Compressor
Control voltage
-
Pipe
For gas
Pipe length
Height difference
Pipe length
added
Note:
location where continuous direct sunlight or excessive
Note:
When operating the air conditioner in low outside tem-
with its air inlet side facing the wall and
on the air outlet side.
Avoid the following places for installation where air
-
in the air.
damaged).
NTXWMT09A111A✱
1.4
15
12
8.8
inch (mm)
1/4 (6.35)
1/2 (12.7)
Up to 25 ft. (7.5 m)
Exceeding 25 ft. (7.5 m)
NTXWMT12A111A✱
14
Insulation
Insulation material
5/16 (8)
Heat resistant
5/16 (8)
5/16 (8)
-