Trane MWW509IB Installation Manual page 18

CAUTION!
All the electrical work must be done
by qualified personnel according to the
local rules and manual.
The rated voltage and the exclusive
circuit must be used.
Leakage circuit-breaker must be
installed.
Please use specified fuse.
The diameter of power cord should be
large enough. Use the exclusive wire to
replace the damaged wire.
Wire work should conform to national
standard.
18
Installation for
Install the indoor unit
1. When routing the piping or wiring from
the left or right side of the indoor unit,
cut off the tailings from the chassis in
necessary (Shown in figure 4)
(1) Cut tailing 1 when routing the power
wire only.
(2) Cut tailings 1 and 2 when routing
both the wiring and pipng.
2. After wrapping the connection tubes and
wire, put them through the wall piping
hole (Figure 5).
3. Hang the grip at the back of the indoor
unit to the hook on the mounting plate,
check if it is firm enough.
Figure 3
MWW530IB/TWK530JB
4. The height of the installation location
should be more than 2.3m from the floor.
Figure 4
Figure 5
MCW - SVN13A - E4