SRAM ROCK SHOX Lyrik Service Manual page 55

3 4 Push the rebound damper shaft into the upper tube to prevent it from
getting scratched while installing the retaining ring.
Retaining rings have a sharper-edged side and rounder-edged side.
Installing retaining rings with the sharper-edged side facing the tool
will allow for easier installation and removal.
Place the tips of the internal retaining ring pliers into the eyelets of the
retaining ring and install the retaining ring into the groove.
NOTI CE
Do not scratch the rebound damper shaft. Scratches will allow oil to
bypass the seal head into the lower leg resulting in reduced spring
performance.
Confirm the retaining ring is properly seated in the retaining ring
groove by using the retaining ring pliers to rotate the retaining ring
and seal head back and forth a few times.
5 6
Pull the rebound damper shaft out to the fully extended position.
55
Rebound Damper Installation