SRAM ROCK SHOX Lyrik Service Manual page 48

3b RCT R: Install the cable stop collar with the housing guide in the 6
o'clock forward position, angled ≈20° degrees from center.
87°
20°
RCT R
Push the low speed adjuster knob spring retainer (A) in and push the
knob out of the remote spool.
Remove the top cap seal.
Clean each part.
A
Install the remote spool onto the hex adjuster with the spool cable set
screw oriented within the 87° range zone.
Install the knob seal.
Install the low speed adjuster knob onto the hex adjuster. Install and
2 mm 1.2 N·m (10 in-lb)
tighten the knob retaining screw.
48
Damper Installation