Siemens SIMATIC ET 200SP Manual page 34

Configuring/address space
4.4 Parameters
Parameter
Reaction to violation of a counting
limit
Reaction to gate start
Measured variable
Time base for velocity
measurement
1
Increments per unit
1
Hysteresis
1
Potential group
This parameter cannot be configured using PROFIBUS GSD file. The parameter is loaded to the module with the default
1
setting and can be adapted using the data record 128.
When a GSD file is used, this diagnostic interrupt is activated via the "Enable additional diagnostic interrupts" parameter
2
and cannot be set separately.
Parameters of the TM PosInput 1 with SSI absolute encoder
If you use an SSI absolute encoder, you can set the following parameters:
Table 4- 5 Configurable parameters and their defaults
Parameter
Operating mode
Reaction to CPU STOP
1
Enable additional diagnostic
interrupts
34
Value range
Stop counting
•
Continue counting
•
Set to start value
•
Continue with current value
•
Frequency
•
Period
•
Velocity
•
1 ms
•
10 ms
•
100 ms
•
1 s
•
60 s/1 min
•
1...65535
0...255
Use the potential group of the left
•
module (dark BaseUnit)
Enable new potential group (light
•
BaseUnit)
Value range
Counting
•
Measuring
•
Output substitute value
•
Keep last value
•
Continue operation
•
Deactivated
•
Activated
•
Default setting
Continue counting
Continue with current
value
Frequency
60 s/1 min
1
0
Use the potential group of
the left module (dark
BaseUnit)
Default setting
Counting
Output substitute value
Deactivated
Technology module TM PosInput 1 (6ES7138-6BA00-0BA0)
Manual, 02/2014, A5E33015755-AA
Re-
configuration
in RUN
Yes
Yes
Yes
Yes
Yes
Yes
No
Re-
configuration
in RUN
No
Yes
Yes