Installing The Compact Ff Link; Installing The Compact Ff Link For Single-Channel Operation - Siemens SIMATIC Compact FF Link Operating Instructions Manual

Mounting

5.3 Installing the Compact FF Link

Mounting position
The active field distributors can be installed in any orientation.
Mounting system
The active field distributors can be screw-mounted onto a flat, vibration-free surface with
sufficient load bearing capacity. The modules can also be installed on a mounting rail using
an adapter.
For trouble-free installation of the modules, a clearance of 60 mm must be maintained on their
side and below them.
For detailed information on installation, refer to Operating Instructions
Field Distributors, DP/PA Link and Y Link .
See also
Active field distributor for connecting FF segments (Page 15)
5.3 Installing the Compact FF Link
5.3.1

Installing the Compact FF Link for single-channel operation

Introduction
The following application is available for the configuration variant with one Compact FF Link:
● Single-channel operation
Configuration with the mounting rail "for standard configuration"
Basic installation steps
Carry out the following installation steps in the order given:
1. Install the mounting rail
2. Install the module on the mounting rail
Components required
Required components for single-channel operation (1 x Compact FF Link)
● Mounting rail "for standard configuration"
● Compact FF Link
26
DP/PA Coupler, Active
Operating Instructions, 03/2015, A5E35651552-AA
Compact FF Link