Basics - Siemens SICAM P 7KG7750 Manual

5

5.1 Basics

5.1 Basics
In order to program your SICAM P via the PC software SICAM P Parameterization you have to
prepare for operation or parameterization:
Preconditions
•
The device is ready to operate.
•
The PC software SICAM P Parameterization (ordering number see chapter 1.3) is installed
on your PC.
•
The parameterization cable set (ordering number see chapter 1.3) or a RS485 converter is
available.
Parameterization
1. Connect the device and the PC as described in the online help.
2. Set the connection parameters on the device:
•
Select the protocol "PC-RS485".
•
Select the baud rate for the connection.
3. Set the connection parameters in the PC software SICAM P Parameterization (Connection
→ Setup connection). Make sure to use the same baud rate.
4. Load the settings from the device (Device → Connection configuration → Receive).
5. Edit the settings in the PC software.
6. Send the new settings to the device again (Device → Connection configuration → Send).
Note
SICAM P Parameterization displays the parameters depending on the ordering number of the
device.
Reading the ID from the device recognizes the device type and sets the functional scope.
Note
All others functions of SICAM P Parameterization are described in the online help (key F1).
82
Power Meter SICAM P 7KG7750/55, Manual
E50417-B1076-C340-A6, Edition 09.2013