Attaching And Removing The Embroidery Tables - Janome Continental M17 Instruction Book

c
Embroidery tables
(large)
!0
z
Embroidery tables
(large)
x
!0
!0
q
w
e
c You can adjust the height of the embroidery tables
to match the height to the top of the machine bed as
necessary.
Adjust the height of the embroidery tables by turning
the height adjusting screw with a Phillips screwdriver*.
Turn the height adjusting screws counterclockwise
(UP) with a Phillips screwdriver to raise the height, or
clockwise (DOWN) to lower the height.
• Counterclockwise (UP): Raise the table height
• Clockwise (DOWN): Lower the table height
!0 Height adjusting screw
* Phillips screwdriver is not included with the machine.

Attaching and removing the embroidery tables

You can replace, attach or remove the upper table covers
without removing the lower embroidery tables.
You can store accessories in lower table boxes.
z Remove the upper table covers as shown.
Upper table cover (small) :
Insert your finger into the hole of the lower table box
and remove the upper table cover as shown.
Upper table cover (large) :
Hold the front underside of the upper table cover and
remove the upper table cover as shown.
q Hole
w Front underside of the table
To attach the upper table cover (either small or
large), hold the upper table cover and press the cover
against the machine (toward the red line), and then
press down the cover.
x You can store accessories in lower table boxes.
e Lower table boxes
33