Attaching The Embroidery Tables - Janome Continental M17 Instruction Book

v
z
Embroidery tables
small
( )
w
r
q
e
x
o
u
u
Embroidery tables
(large)
y
r
t
e
i
u
v You can adjust the height of the embroidery unit to
match the height to the top of the machine bed as
necessary.
Adjust the height of the embroidery unit by turning the
height adjusting screw with the screwdriver. Turn the
height adjusting screw counterclockwise (UP) to raise
the height, or clockwise (DOWN) to lower the height.
u Height adjusting dial
CAUTION:
• Do not set the height of the embroidery unit too
low. The rollers on the bottom of the embroidery
unit must be in contact with the ground. Setting the
embroidery unit height too low may cause rattling of
the unit or skipped stitches.
• Use the screwdriver that came with the machine.
• Do not apply excessive force to the embroidery
unit, otherwise it may cause damage to the unit's
mechanism.

Attaching the embroidery tables

There are two pairs of embroidery tables.
Embroidery tables (small): for SQ10d, RE20d, ASQ27d,
SQ28d.
Embroidery tables (large): for RE46d only.
* Attach the embroidery tables (small) for the Ordinary
Sewing mode.
The embroidery tables are composed of two parts; an
upper table cover (small or large) and a lower table box
(common). Select upper table covers as desired and
attach them to lower table boxes.
You can store accessories in lower table boxes.
z Attach upper table large/small covers (front and rear)
to lower table boxes gently.
q Upper table small cover (front)
w Upper table small cover (rear)
e Lower table boxes (front)
r Lower table boxes (rear)
t Upper table large cover (front)
y Upper table large cover (rear)
NOTE:
Be sure to attach the upper table covers firmly to the
lower table boxes.
x Attach embroidery table (front) and embroidery table
(rear) to the embroidery unit as shown.
Be sure to slide embroidery tables against the unit
while aligning the height of tables to the embroidery
unit.
u Embroidery table (front)
i Embroidery table (rear)
o Embroidery unit
32