Automatic Needle Threader - Janome Continental M17 Instruction Book

z
q
x
c
v
t
n
e
r
b
y

Automatic Needle Threader

NOTE:
• The needle threader can be used with a #11 to #16
needle.
• Thread size 50 to 90 is recommended.
• Do not use thread size 30 or thicker.
• The needle threader cannot be used with the twin
needle.
z Press the needle up/down button to raise the needle.
Press the lockout key to lock the machine.
w
q Needle up/down button
w Lockout key
x Draw the thread through the slit of the needle
threader. The thread should pass under the hook.
e Slit
r Hook (red part)
c Pull the thread up and slip it between the thread cutter
and face plate from behind.
Pull the thread toward you to cut.
v Press the needle threader button.
t Needle threader button
b The needle thread will be automatically threaded
through the needle eye.
n Pull the thread loop to take the thread end out through
the needle eye to the rear.
y Thread loop
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
29