Janome Continental M17 Instruction Book page 126

Problem
A crunching 1. Something is caught between the carriage and the arm.
sound occurs 2. The carriage is hitting something around the machine.
when running the
machine.
The embroidery 1. The needle thread tension is too loose.
patterns are 2. Interfacing is not used for sewing stretch and very fine fabrics.
distorted. 3. The embroidery hoop is hitting something around the machine.
4. The fabric is not stretched tightly enough on the embroidery
5. The fabric is caught or trapped when sewing embroidery.
6. The embroidery foot is caught by a jump thread.
7. The embroidery foot catches on a clump of embroidery threads.
Pattern selection 1. The electronic control circuit is not working correctly.
keys do not work.
Threads frequently 1. The minimum length of jump thread cutting is too short.
bunch up on the
underside of the
stippling design
pattern.
The automatic 1. The automatic needle threader is not working correctly.
needle threader
does not return to
up position.
The machine 1. The wireless router device does not comply with IEEE802.11b/g/n
cannot connect to
the wireless LAN 2. The wireless router device using WEP security, and encryption
access point.
The machine's 1. The wireless router device's DHCP option is not turned on.
wireless LAN 2. A microwave oven, bluetooth device or cordless phone is being
connection is
unstable.
Wireless LAN 1. The wireless LAN setting mode is selected too soon after the
connection ON/
OFF keys are
grayed out on 2. The electrical circuit does not work properly.
the wireless LAN
setting mode.
The wireless LAN 1. The wireless LAN setting was not completed correctly.
setting has been
set, but the signal
strength icon is 2. The electrical circuit does not work properly.
grayed out on
the upper right
corner of the right
touch screen and
the machine can
not connect to the
wireless LAN.
The USB flash 1. Format setting of the USB flash drive is not correct.
drive is not read. 2. The USB flash drive is malfunctioning.
hoop.
wireless standard.
type or/and key index is not set correctly.
used between the machine and the access point.
machine is turned on.
Cause
122
Reference
Remove the object.
Page 31.
Page 53.
Use interfacing.
Page 31.
Pages 38-39.
Stop the machine and
free the fabric.
Trim the jump thread.
Adjust the foot height
(Page 53).
Turn off and then turn
on the machine.
Page 102.
Page 123.
Page 105.
Page 105.
Page 108.
Page 105.
Wait for a while before
entering the wireless
LAN setting mode.
Turn off and then turn
on the machine.
Complete the wireless
LAN setting correctly
(refer to pages 105-108).
Turn off and then turn
on the machine.
Pages 124-125
Replace the USB flash
drive.