Table of Contents
Advertisement
Quest Elite QLT 2000 HC & Quest Elite QLT 2000
Daily – Flushing the system
1. Open the cabinet door. Move both LH and RH flush switches from the "Run" position to
the "Flush" position and close the cabinet door.
2. Place a small, empty, cold-drink cup on the drip tray under the nozzles.
3. Push the Cancel/Pour dispenser switches and hold down for 2 or 3 seconds, until clear
water is dispensed from both nozzles.
4. Open the cabinet door. Move the flush switches from the "Flush" position to the "Run"
position and close the cabinet door.
5. Turn the nozzle to the left or right ¼ turn and pull down to remove the nozzle and static
mixer. Take the nozzles and static mixers to the three-compartment sink. Rinse both with
hot tap water to remove any pulp.
6. Reinstall the nozzles and static mixers on the dispenser.
7. Wipe down the outside of the cabinet and the splash panel with a clean, sanitized towel
sprayed with McD APSC solution. Place the towel in the soiled towel bucket.
Publication Number: 620054882
PLANNED MAINTENANCE
- 14 -
© 2011-2013, IMI Cornelius Inc.
Advertisement
Table of Contents
