Table of Contents
Advertisement
Quest Elite QLT 2000 HC & Quest Elite QLT 2000
P
ROGRAMMING THE
A. Simultaneously, press and hold "small" and "extra large" push button switches on the Portion Control Module until
the "REFILL" light in the corner of the module starts blinking. Release the switches. The blinking light indicates the
programming mode is active.
B. Place the cup under the white mixing valve nozzle and push the selected size button (small, medium, large, or extra large). Hold
the button in until the cup fills to the desired portion, then release the button. Repeat the above procedure for the remaining
sizes.
C. After programming all the drink sizes, press and release the "STOP BUTTON" to return the Portion Control to the operational
mode. The blinking REFILL light will go out.
If at a future date it is decided to change the portion size of the drinks, the individual sizes can be adjusted by the
above procedure. It is not necessary to reprogram every size. Additionally the portion control has a full memory
retention in case of a power failure.
To pour a drink without using a pre-programmed portion control size, simply push and hold the STOP BUTTON.
Release when the glass is full.
L
W
OADING
ITH
1. Place the empty pouch holder on its back onto the counter.
2. Grab the pouch by the tube connector and place it vertically
on the counter next to the pouch holder.
3. Locate the silicon tube through the slot and slide the top of the
pouch inward.
NOTE: Do not pull the silicone tube to guide the pouch
into the pouch holder.
Tilt the pouch holder forward while pushing the connector
and tube into the proper slot position.
Publication Number: 620054882
P
C
ORTION
ONTROL
C
ONCENTRATE
P
– 6.5 L
OUCHES
- 8 -
ITERS
© 2011-2013, IMI Cornelius Inc.
Advertisement
Table of Contents
