Korg D1200 Owner's Manual page 53

The tempo map of the specified measure(s) will be
replaced, but the overall number of measure will not
change.
1 Verify the location at which you want to insert a tempo
map.
• Display the tempo map list, and check the current
tempo map.
2 Create the new tempo map.
• Select the "NEW" button and press the [ENTER] key
to open the dialog box.
• Set the parameters.
• Turn the "Insert" button "Off," and press the [YES/
OK] key.
3 Verify that the tempo map was replaced as you
expected.
• Display the tempo map list, and check the tempo
map.
Deleting a tempo map
The maps located after the deleted map will move for-
ward by the number of measures that were deleted.
1 Select the tempo map that you want to delete.
• Display the tempo map list, and select the appropri-
ate tempo map.
2 Delete the tempo map.
• Select the "Delete" button. A message of "Are You
Sure?" will ask you to confirm.
• Press the [YES/OK] key, and the selected tempo map
will be deleted.
If you turn the "Select All" button "On," all maps other
than "001" will be deleted, and the settings of map
"001" will also be deleted.
3 Verify that the tempo map was deleted.
• Display the tempo map list, and verify that the map
was deleted.
This operation cannot be undone.
• If you want to edit the tempo map, select the "Edit"
button and press the [ENTER] key to open the dialog
box. Edit the parameters as necessary. Press the
[YES/OK] key to accept the new settings.
Tempo track
The tempo track records MIDI clock data from an external
MIDI sequencer, or tap tempo data.
Recording MIDI Clock data from an external MIDI
sequencer, and using it as the tempo track
Here's how MIDI Clock data from an external MIDI
sequencer can be recorded as tempo data on the tempo
track.
You can use this when you want to synchronize a D1200
song with song data created on a MIDI sequencer in
which the tempo changes continuously.
1 Specify the time signature of the song.
If the time signature of the song data created on your
MIDI sequencer changes during the song, create a new
tempo map that begins where the time signature
changes. ( p.49)
If you want the time signature to change during the
song, you must create tempo maps accordingly. Tempo
settings will play back in synchronization, but measures
will become incorrectly aligned if the time signature
changes do not match.
2 Connect the MIDI OUT connector of your MIDI
sequencer to the D1200's [MIDI IN] connector.
3 Set your MIDI sequencer so that it will transmit MIDI
Clock messages.
Refer to the owner's manual of your MIDI sequencer.
4 Select how tempo will be recorded.
In the [RHYTHM] "TmpTrk" tab page, select "MIDI
Clock."
Operation
51