Meter/Track View - Korg D1200 Owner's Manual

METER/TRACK VIEW

Here you can view the pre-fader level meters and post-fader
level meters. You can also use the track view display to check
whether each track contains audio events.
From the top, each level meter segment indicates CLIP, –3,
–6, –9, –12, –18, –24, –33, –42, –52, and –66 dB.
1
3
1. Select DisplayMode ...........................................
[PreFaderLev, PostFaderLev, TrkView1–6,
TrkView7–12, TrkView1–12]
Selects the signals that you want to view.
Press the " " button to open the dialog box and make a
selection. Press the [YES/OK] key to activate your selec-
tion, or press the [NO/CANCEL] key to cancel.
PreFaderLev: Display the pre-fader levels of the mixer
channels.
PostFaderLev: Display the post-fader levels of the mixer
channels.
TrkView1–6: Display tracks 1–6.
Areas where audio events exist are shown by a heavy
line. The current location will always be in the center of
the display.
1a. ScaleChangeSW.................. [(5, 10, 20, 40)]
Changes the size of the region that is displayed in the
track view screen. Each time you press this button, the
scale will step through the magnification settings in the
range of 5 sec–40 sec. The button will be displayed as
" " when expanding the displayed region, and as
" " when shrinking the displayed region.
5sec: Display five seconds before and after the current
locate point.
10sec: Display ten seconds before and after the current
locate point.
20sec: Display twenty seconds before and after the cur-
rent locate point.
40sec: Display forty seconds before and after the current
locate point.
TrkView 7–12: Display tracks 7–12 ( "TrkView1–6")
TrkView 1–12: Display tracks 1–12 ( "TrkView1–6")
2. Snd1, 2/MonL, R/MstL, R ..................................
These are the level meters for "Snd1, 2" (effect sends 1,
2), "MonL, R" (monitor L, R), and "MstL, R" (master L,
R).
"MstL, R" is also displayed at the right edge of the page
in [SONG], [TRACK], [BOUNCE], and [EQ] modes, al-
lowing you to check the master LR level.
3. PkHold............................................. [0...8s,
Specifies the time that the maximum level of the level
meter is held in the display.
2
This setting applies to the level meters of all pages. Press
the "PkHold" button to open the dialog box, and make
the desired setting. Press the [YES/OK] key to apply
your selection, or press the [NO/CANCEL] key to can-
cel it.
0...8s: 0–8 seconds
: The peak hold indicator will be held forever. The
hold indicator will be cleared when you use the
"PkHold" indicator to open the dialog box.
1a
Reference
]
125