Adding Eq (Equalization) To Each Track - Korg D1200 Owner's Manual

5 Specify the channel where you want to insert the effect.
Select the "InsertTo:" button, and press the [ENTER] key to open the
dialog box.
For each effect, turn the [VALUE] dial at "SelectCh" to select the
input (output) channel. For this example, set effect 1 to channel"3."
When you have made the setting, press the [YES/OK] key.
6 Select an effect program.
In the insert effect "InsEff1" tab page, select the effect program that
you want to use.
Select "EffectNumber," and turn the [VALUE] dial to select an effect
program.
7 Press the [PLAY] key to begin playback.
You can also select an effect program while you listen to the play-
back.

2. Adding EQ (equalization) to each track

1 Press the [EQ] key.
Select the [EQ] "EQ1–4," "Eq5–8," or "Eq9–12" tab page that contains
the EQ settings you want to adjust.
2 Select the EQ you want to adjust.
The following EQ controls are provided for each channel.
3 Adjust the gain and frequency.
Adjusting the gain in the "–" direction will cut the sound, and in the
"+" direction will boost the sound.
Raising the mid EQ frequency setting will cause the mid-range
boost/cut to affect a higher frequency range. Lowering it will cause
the boost/cut to affect a lower frequency range.
4 Press the [PLAY] key to start playback.
You can also adjust the EQ while you listen to the playback.
26
Low EQ gain (L)
High EQ gain (H)
Mid EQ gain (M)
Mid EQ frequency (F)
EQ ( p.37, 88)