Scan Resume Methods; Selecting Scan Resume Method - Kenwood TH-G71E Instruction Manual

SCAN RESUME METHODS

Before using Scans other than Priority Scan, it's
necessary to decide under what condition you want your
transceiver to continue scanning after detecting and
stopping for a signal. You can choose one of the
following modes. The default is Time-Operated mode.
• Time-Operated mode
Your transceiver stops scanning when detecting a signal,
remains there for approximately 5 seconds, and then
continues to scan even if the signal is still present.
• Carrier-Operated mode
Your transceiver stops scanning when detecting a signal
and remains on the same frequency until the signal drops
out. There is a 2 second delay between signal drop-out and
scan resumption to allow time for any responding stations to
begin transmitting.
• Seek mode
Your transceiver stops scanning when detecting a signal
and remains on the same frequency; the transceiver stays
on this frequency even after the signal drops out and does
not automatically resume scanning.
Pressing and holding
Note: [MONI]
scanning; releasing [MONI] causes it to resume scanning.
causes the transceiver to stop
■

Selecting Scan Resume Method

1 Press [F], [BAND] to enter Menu mode.
2 Select Menu No. 1 (SCAN).
3 Press [BAND] to select Time-Operated (TO),
Carrier-Operated (CO), or Seek (SE) mode.
4 Press any key other than [BAND], [LAMP], and
[MONI] to exit Menu mode.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
25