Kenwood TH-G71E Instruction Manual page 3

MICROPHONE CONTROL
NOTICES TO THE USER
ATTENTION (U.S.A. Only):
The RBRC Recycle seal found on
nickel-cadmium (Ni-Cd) battery packs indicates
's voluntary participation in an industry
KENWOOD
program to collect and recycle Ni-Cd batteries after
their operating life has expired. The RBRC program
is an alternative to disposing Ni-Cd batteries with
your regular refuse or in municipal waste streams,
which is illegal in some areas.
For information on Ni-Cd battery recycling in your area, call (toll free)
1-800-8-BATTERY (1-800-822-8837).
's involvement in this program is part of our commitment
KENWOOD
to preserve our environment and conserve our natural resources.
One or more of the following statements may be
applicable:
FCC WARNING
This equipment generates or uses radio frequency energy. Changes
or modifications to this equipment may cause harmful interference
unless the modifications are expressly approved in the instruction
manual. The user could lose the authority to operate this equipment
if an unauthorized change or modification is made.
INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY
THE FCC
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can generate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that the interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that
•
to which the receiver is connected.
Consult the dealer for technical assistance.
•
KENWOOD
Please observe the following precautions to prevent
fire, personal injury, or transceiver damage:
• Do not transmit with high output power for
• Do not modify this transceiver unless instructed by
• When using a regulated power supply, connect the
• When connecting the transceiver to a cigarette
• Do not expose the transceiver to long periods of
• Do not place the transceiver in excessively dusty
• If an abnormal odor or smoke is detected coming
PRECAUTIONS
extended periods. The transceiver may overheat.
this manual or by KENWOOD documentation.
specified DC cable (option) to the DC jack on the
transceiver. The supply voltage must be between
6 V and 16 V to prevent damaging the transceiver.
lighter socket in a vehicle, use the specified
cigarette lighter cable (option).
direct sunlight nor place the transceiver close to
heating appliances.
areas, humid areas, wet areas, nor on unstable
surfaces.
from the transceiver, turn OFF the power
immediately and remove the battery case or the
battery pack from the transceiver. Contact a
KENWOOD service station or your dealer.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
i