Kenwood TH-G71E Instruction Manual page 51

Problem
You cannot transmit 1 You selected a frequency outside the
even though you
press the PTT 2 You selected a transmit offset that
switch.
3 The TX Inhibit function is ON.
4 The Tone Alert function is ON.
The transceiver The Automatic Power Off (APO) function
switches OFF for no
is ON.
apparent reason.
Packet operation 1 Physical connections between the
results in no
connects with other
stations.
2 Different transmit and receive
3 The modulation level from the TNC is
4 There is multi-path distortion.
5 The squelch is open.
Probable Cause
allowable transmit frequency range.
places the transmit frequency outside
the allowable transmit frequency
range.
transceiver, computer, and TNC are
incorrect, or software settings in the
TNC are wrong.
frequencies are being used. Usually,
you must use the same transmit and
receive frequency for packet.
incorrect.
Corrective Action
1 Select a frequency within the
allowable transmit frequency range.
2 Press [F], [REV] repeatedly so
neither "+" nor "–" is visible.
3 Switch OFF the TX Inhibit function.
4 Switch OFF the Tone Alert function.
Switch OFF the APO function.
1 Recheck all connections using this
manual, your TNC manual and your
computer hardware manual as
reference.
2 If using VFO mode, switch OFF the
transmit offset. If using Memory
Recall, select a simplex memory
channel.
3 Adjust the TNC modulation level
according to the TNC manual.
4 Reorient the antenna. The
strongest
signal does not always provide the
best operation on packet.
Page
Ref.
1
9
2
13
3
37
4
38
5
37
6
48
7
8
13, 17
9
10
—
11
—
12
8
13
14
15
45