Setting The Fuel Alarm; My Vessel Settings; Setting The Keel Offset - Garmin Volvo Penta GLASS COCKPIT 8x10 Owner's Manual

such as a GXM device, and have a valid weather
subscription.
1 Select Options > Settings > Alarms > Weather.
2 Turn on alarms for specific weather events.

Setting the Fuel Alarm

The Beeper setting must be turned on to make alarms
audible (Sounds and Display Settings, page
to set audible alarms could lead to injury or property
damage.
You can set an alarm to sound when the total amount of
remaining onboard fuel reaches the level you specify.
1 Select Options > Settings > Alarms > Fuel.
2 If necessary, select a driveline.
3 Select On.
4 Enter the remaining amount of fuel that triggers the
alarm.
5 If necessary, repeat steps 2–4 for all drivelines.

My Vessel Settings

NOTE: Some settings and options require additional
charts or hardware.
Select Options > Settings > My Vessel.
For more information, refer to the Volvo Penta manual.
Transducers: Shows all transducers on the network,
allows you to change transducers, and allows you to
view diagnostic information
Type, page 40).
Depth and Anchoring: Allows you to enter information
about the keel (Setting the Keel Offset, page
the anchor.
The Anchor Height value is the height of the anchor
above the waterline. The Anchor Scope value is the
ratio of the length of anchor rode in use to the vertical
distance from the bow of the vessel to the bottom of the
water. These anchor settings are used to calculate the
Target Anchor Rode date field.
Temp. Offset: Allows you to set an offset value
to compensate for the water temperature reading
from a NMEA 0183 water-temperature sensor or a
temperature-capable transducer
Temperature Offset, page
Calibrate Water Speed: Calibrates the speed-sensing
transducer or sensor (Calibrating a Water-Speed
Device, page 86).
Switching: Sets the digital switching circuits, such as
SeaStar ® and CZone ™
e-KEY Management: Allows you to manage the electronic
keys (e-KEYs).
Drive Type: The setting should be changed by authorized
Volvo Penta personnel only.
ACP Mode: Sets the ACP protection mode.
Device Configuration
CAUTION
81). Failure
(Selecting the Transducer
35) and
(Setting the Water
86).
devices.
Toe Angle: The setting should be changed by authorized
Volvo Penta personnel only.
Speed Factor: Calibrates the displayed boat speed.
PTA Settings: Allows you to enter new maximum limits
for the PTA modes.
Fuel Tank: Sets the fuel tank settings.
Seven Marine Installation: Sets the Seven Marine
engine settings.
Hull ID Number: Allows you to enter the Hull Identification
Number (HIN).The HIN might be permanently affixed
to the upper starboard side of the transom or outboard
side.
Ignition Auto Off: Turns off the ignition automatically after
the engines have been off for the selected length of
time.
Optimus Steering: Allows you to adjust the Optimus
steering parameters.

Setting the Keel Offset

You can enter a keel offset to compensate the water
depth reading for the transducer installation location. This
allows you to view the depth of the water below the keel or
the true depth of the water, depending on your needs.
If you want to know the water depth below the keel or the
lowest point of your boat and the transducer is installed
at the water line or anywhere above the end of the keel,
measure the distance from the transducer location to the
keel of the boat.
If you want to know the true water depth and the
transducer is installed below the water line, measure the
distance from the bottom of the transducer up to the water
line.
85