Set Water Softening; Softening Salt - Bosch SGS4HTI33E User Manual

Water hardness °dH
7 - 8
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
Remark: Set the device to the
determined water hardness.
→ "Set water softening", page
23
With a water hardness of 0 - 6 °dH
you do not need to use softening salt
for dishwashers and you can switch
off the water softening.
→ "Switching off water softening",
page 24

Set water softening

Set the device to the water hardness.
Determine the water hardness and
1.
the desired setpoint.
→ "Overview of the water
hardness settings", page 22
Press.
2.
Approx. 3 seconds on
3.
to access the basic settings.
a The display shows Hxx. a
The display shows
to give.
Just as often on
4.
the desired water hardness has
been set.
The factory setting is H04.
To save the settings, press . for
5.
about 3 seconds
Hardness Range
soft
average
average
average
hard
hard
hard
Busy-
reflected
press until
to press.
mmol/l
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9

Softening salt

You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the program
starts. The amount of softening salt
required depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
NB!
sex Dishwasher detergent can damage the water
damage hardening.
Only fill the water softener
▶
reservoir with dishwasher
softening salt.
sex The rinse aid container can be
softening salt for dishwashers
corrode.
To ensure that spilled softening
▶
salt is rinsed from the rinse aid
container, the softening salt must
be filled into the softening salt
reservoir immediately before the
program starts.
Softening System NL
Set value
H01
H02
H03
H04
H05
H06
H07
23