Set Water Softening; Softening Salt - Bosch SPS6ZMW35E Instructions Manual

Water hardness °dH
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
NoteSet the device to the
determined water hardness.
→ †Set water softening", page
27
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
→ †Switching off water softening",
page 28

Set water softening

Set the device to the water hardness.
Determine the water hardness and the
1.
desired setting value.
→ †Overview of the water
hardness settings", page 26
Press.
2.
Approx. 3 seconds on
3.
to access the basic settings.
aThe display shows H:xx
to give.
aThe display shows
to give.
Just as often on or
4.
the desired water hardness has
been set.
The factory setting is H:04.
To save the settings, press . for
5.
about 3 seconds
Hardness Range
average
average
average
hard
hard
hard
Busy-
reflected
press until
to press.
mmol/l
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9

Softening salt

You can soften the water with
softening salt.
Filling softening salt
If the Refill softener salt indicator
lights up, top up the softener salt in
the softener salt reservoir
immediately before the program
starts. The amount of softening salt
required depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
PAY ATTENTION!
†Dishwasher detergent can damage the water
damage hardening.
Only fill the water softener
▶
reservoir with dishwasher
softening salt.
†The rinse aid container can be
corrode softening salt.
To ensure that spilled softening
▶
salt is rinsed out of the rinse aid
container, fill the softening salt
into the softening salt reservoir
immediately before the program
starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill the
2.
reservoir completely with water.
Softening SystemNL
Set value
H:02
H:03
H:04
H:05
H:06
H:07
27