Table of Contents
Advertisement
NL
Basic settings
B asis settings
YOU can set up your device according to your needs.
Overview of the basic settings
The basic settings depend on the equipment of your appliance.
Basic setting
water hardness
rinse aid
lilac
Intensive drying
hot water
Factory setting
1
Factory setting (may differ depending on the device type)
34
Display text
Choise
H04
H00 - H07
1
r05
r00 - r06
1
d00
d00 - d01
1
A00
A00 - A01
1
re
YES
Description
Set the water softener to the water
hardness.
→ "Set water softening",
page 23
At position H00 the water
softening is switched off.
Set the amount of rinse aid.
→ "Setting the rinse aid
amount", Page 26
Switch off the rinse system
with position r00.
When rinsing, the temperature is
increased, which results in better
drying results. As a result, the
running time may increase slightly.
Remark: Not suitable for
delicate items of crockery.
Switch on intensive drying "d01"
or switch off "d00".
Set cold water connection or hot
water connection. Only set the device
to Hot water if the hot water is
prepared in an energy-efficient
manner and if a suitable installation is
available, e.g. a solar cylinder with a
circulation line. The water
temperature must be a minimum of
40 °C and a maximum of 60 °C.
Switch on hot water "A01" or
switch off "A00".
Reset changed settings to
factory condition.
Initial commissioning
settings must be specified.
Advertisement
Table of Contents
