Set Up And Connection; Scope Of Delivery; Device; Waste Water Connection - Bosch SGS4HTI33E User Manual

NL Set up and connect
Set up and connect
s For correct use, connect the
appliance to electricity and water in a
professional manner. Observe the
required criteria and the installation
instructions.
Scope of supply
After unpacking, check all parts for
transport damage and the
completeness of the delivery.
For complaints, please contact the
store where you purchased the
device or our customer service.
Remark: The device has been checked
at the factory for correct operation.
Water stains may remain on the
device. The water spots will disappear
after the first wash cycle.
The delivery consists of:
sex Dishwasher
sex Instructions
sex Assembly instructions
sex Other documents containing information
tie
sex mounting material
sex Power cord
sex Quick guide
Set up and connect the

device

You can install your under-counter or
built-in appliance in the kitchen unit
between wooden and plastic walls. If
you subsequently install the device as
a free-standing device, you must
secure the device against tipping over,
e.g. by screwing it to the wall or
installing it under
12
a continuous worktop that is
permanently connected to the adjacent
cabinets.
Observe the safety instructions." →
1. "
Page 4
Observe the instructions for the
2. "
electrical connection."
→ Page 13
Check the contents of the package
3.
and the condition of the device.
The required installation dimensions can be found
4.
in the installation instructions.
Level the appliance using the
5.
adjustable feet.
Pay attention to a firm position.
Install the waste water connection."
6. "
→ Page 12
Install the drinking water
7. "
connection." → Page 13
Connect the device to the
8.
power.

Waste water connection

Connect the appliance to a waste water
connection so that the contaminated
washing water can be drained.
Install waste water connection
The necessary steps can be found in
1.
the supplied installation instructions.
Connect the drain hose to the
2.
connection nipple of the siphon
using the supplied parts.
Make sure that the drain hose is not
3.
kinked, crushed or tangled.
Make sure that the water does not
4.
flow out by a plug in the waste
water connection.