Canon imageRUNNER 1019J Service Manual page 22

F-2-35
2. When mounting the IP cover, take care so that the
USB port [1] will not damage the grounding plate
[2].
Also, after mounting the IP cover, check to be
sure that the grounding plate [2] is firmly in
contact with the USB port [1].
[1]
[2]
F-2-36
14) Mount the removed parts.
- cable guide
- modem PCB (if found)
- LAN cable connector
[1]
[2]
[2]
press in response will cause automatic execution of
When mounting the LAN cover, take care so that the
LAN port [1] will not damage the grounding plate
[2].
Also, after mounting the LAN cover, check to be
sure that the grounding plate [2] is in firm contact
with the LAN port [1].
[1]
[2]
F-2-37
16) Mount back the parts that have been removed:
- RAM
- RAM cover
- IP modem cable (if modem PCB is found)
- rear cover
- reader unit rear cover
- reader unit rear cover (small)
17) Connect the power plug to the wall outlet, and
turn on the main power switch.
MEMO:
When the main power switch is turned on, the
message "CHECK SUM ERROR" will appear. A
'ALL CLEAR'. If it fails to start on its own, use
service mode to execute it.
Chapter 2
[2]