Pri Options - Samsung OfficeServ 500 Programming Manual

[427] PRI OPTIONS

This MMC allows the technician to program a PRI trunk board.
No Option
0 CHANNEL ANY
1 PRI MODE
NORMAL
DID
2 DLSEND
ENBLOCK
OVERLAP
3 CLIP TABLE
4 NB TYPE
UNKNOWN
INT.NAT
NATIONAL
NETWORK
SUBSCRIB
EXTEN
ABBREV
5 NB PLAN
UNKNOWN
ISDN
DATA
TELEX
NATIONAL
PRIVATE
EXTEN
© SAMSUNG Electronics Co., Ltd.
When this option is set to YES, the system will place calls on any free
channel of that PRI if the channel chosen by the user is busy. If set to
NO, you will receive a busy signal if they attempt to access a busy
channel even if the other channel on that PRI is free.
PRI access mode select.
Point to Point NORMAL. This operates like a standard telephone line
with one CO number per channel and ring according to MMC 406.
Point to Point Direct Inward Dial. This operates in a similar manner to an
analog DID circuit with multiple CO numbers pointed to a single channel
and translated within the system(MMC714) to a single device.
PRI dial sending mode select.
Digits will be collected and sent in a single block similar to a Cell phone.
Digits will be sent as they are dialed by the user.
Used to select the Calling Party Number to send to the network. In case
of NONE, MMC405 CO TRUNK NUMBER is sent to the network. In
other cases, MMC 323 Calling Party Number entry corresponding with
the selected number is sent to the network.
Used to select the type of the Calling Party Number to send to the network.
Unknown number
International number
National number
Network specific number
Subscriber number
Local number
Abbreviated number
Used to select the type of the Calling Party Number Plan to send to the
network.
Unknown numbering plan
ISDN numbering plan(CCITT E.163-164)
Data numbering plan(CCITT X.121)
Telex numbering plan(CCITT F.69)
National standard numbering plan
Private numbering plan
Local numbering plan
OfficeServ 500 Programming Guide
Description
2-143