Inventory - Grizzly G0704 Owner's Manual

Inventory

The following is a description of the main compo-
nents shipped with your machine. Lay the compo-
nents out to inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
contents
A. mill/drill w/stand ......................................... 1
b. open end Combo Wrench 17/19 ................ 1
c. open end Combo Wrench 8/10 ................. 1
D. bottle for oil ............................................... 1
E. tool box...................................................... 1
f.
large handwheel handle ........................... 1
G. small handwheel handles ......................... 3
H. t-bolts m10-1.5 x 60 (vise mounting) ......... 2
Flat Washers 10mm (vise mounting) .......... 2
hex nuts m10-1.5 (vise mounting).............. 2
I.
drill Chuck .................................................. 1
J. Chuck Key .................................................. 1
K. phillips screwdriver .................................... 1
L. Flat screwdriver .......................................... 1
M. arbor b16 x r8 ........................................... 1
N. hex Wrench set 2, 3, 4, 5, & 6mm ...... 1 ea.
O. spindle pin ................................................. 1
Not Shown:
hex bolts m10-1.5 x 50 .............................. 4
Flat Washers 10mm ................................... 4
-14-
Qty
figure 4. g0704 out of the crate.
If you cannot find an item on this list, care-
fully check the machine and the packaging
materials. Some of these items may be pre-
installed for shipping or become misplaced
during unpacking.
K
J
a
NOTICE
d
b
C
m
l
n
i
h g
figure 5. inventory.
model g0704 (mfg. since 08/11)
e
o
F