Glass Reflective Panels; Fluted Panels - Montigo D3615 Installation & Maintenance Manual

Decorative panel Installation
Glass reflective panels
SEE-THROUGH UNITS NOTE: see through units panel kits include only
the two side panels, follow step 2 of the below to complete installation.
Step 1: Slide back panel(s) into top track, carefully push the base of the
panel onto the lower ledge.
TOP TRACK
Figure 26. Remove the existing screws
Step 2: Side panels are slid into the lower track and set into place using
the provided bracket and screws. Use 1/4'' hex bit
Figure 26.c Secure panel
36

Fluted panels

SEE-THROUGH UNITS NOTE: see through unit panel kits include only
the two side panels, follow step 4 of the below to complete installation.
Step 1: Bend tabs on bottom
bracket slightly up, seat in track
of back wall.
Figure 26.b Secure bottom of panel
Step 3: Place top brackets on to
track at the top and bend tabs
down, one per panel.
Figure 26.d Secure top and sides
Installation
Step 2: Place back liners, making
sure they interlock properly.
Bend tabs fully to secure.
Step 4: Place side liners, secure
with self tapping tek screw and
side brackets. Repeat other side.
XG0222