Section 6: Installing The Accessories; Installing The Logs And Embers; Installing The Glass Beads - Montigo H38SVO-ST Series Installation & Maintenance Manual

Section 6: Installing the Accessories

Installing the Logs and Embers
Bottom Logs
The H38VO-ST* is supplied with eight (8) fibre logs. The two small
bottom logs ("A" ) are mounted on the burner grate by placing them
diagonally onto the supplied Log stands. The long Front / Back
logs ("B") are placed against the grate as shown in Figure 7b. Note:
When placing logs, arrange Logs "B" as not to cover Burner holes.
Top Logs
Next are the logs "C" which are placed diagonally, as shown in
Figure 7c. The last Logs "D" are then mounted on top of logs "A"
as shown in Figure 7d.
A
Log Stand
B
C
D
XG0817
A
Burners
Log Stand
Figure 7.a
B
Figure 7.b
C
Figure 7.c
D
Figure 7.d
Figure 7.e

Installing the Glass Beads

The HL38VO-ST* is supplied with Designer Glass beads. Remove
the Door as shown on page 10.
Once the glass door(s) are removed place the glass beads across
the pan surrounding the burners as shown in Figure 7.f
NOTE: DO NOT Cover burners with beads or the optional rocks.
WARNING
Do not attempt to clean glass when hot. Do not clean glass with
abrasive materials. Any glass etching may cause premature glass
failure. Do not operate this fireplace without the glass door or with a
broken glass door.
Installation
Figure 7.f
11