Section 8: Installing & Removing The Glass - Montigo PCPR8 Installation & Maintenance Manual

Section 8: Installing & Removing the Glass
The Prodigy fireplace has 2 layers of glass that must be removed for
maintenance and cleaning. Remove the glass as follows:
1) Place suction cups on the glass door. Follow the instructions supplied
with this product to ensure all safety instructions are observed. Ensure
cups are firmly attached and secured.
2) Hold handles firmly and lift the glass panel up and out of the lower track
(into the upper track). Tilt the lower edge of the glass outwards. Do not
tilt the glass away from the bottom track by more than 1" to avoid putting
pressure on the glass in the top track.
3) Slide the glass downward carefully until it is free from the upper clips.
Store in a safe location until time to replace.
4) At each end of the unit between the inner glass and outer glass there
is a channel held in place by 2 screws. Remove these screws and the
channel and store them in a safe place for re-installation.
5) Repeat steps 2 & 3 to remove the inner glass.
6) To re-install the glass, use the suction cups to carefully slide the glass
into the clips on the upper track with the bottom tilted outward. Carefully
lower the bottom of the glass toward the unit until it is in line with the
lower track and gently lower onto the rubber stoppers in the bottom
of the track.
XG0799 - 081319
Installation
27