Approaches With Procedure Turns - Garmin GNS 530AW Pilot's Manual & Reference

5 - PROCEDURES
Procedure Turn Approach
Approach operations on the 500W-series units
typically begin with the same basic steps:
Basic Steps for Using Approaches
1. Select the destination airport using the direct-
to key, or as the last waypoint in the active
flight plan.
2. Choose the "Select Approach?" option from
the Procedures Page or from the Active Flight
Plan Options.
3. "Load" the approach (often while en route) in
anticipation of its future use. This places the
approach in the active flight plan, but retains
course guidance in the en route section until
the approach is "Activated".
86
DO NOT USE FOR
NAVIGATION
190-00357-00 Rev G
4. "Activate" the full approach or vectors-to-final,
as appropriate. In some scenarios, you may find
it more convenient to immediately activate
the approach and skip the "Load" process
outlined above in step #3. The 500W-series
units provide both options.

Approaches with Procedure Turns

The procedure turn portion of an approach is
stored as one of the legs of the approach. For this
reason, the 500W-series unit requires no special opera-
tions from the pilot — other than flying the procedure
turn itself — beyond what is required for any other
type of approach. Roll steering is provided to aircraft
with compatible autopilots.
Lynchburg (VA) Regional
VOR or GPS Rwy 04
[RW04]
This example uses the VOR or GPS Runway 04
approach for Lynchburg (Virginia) Regional Airport,
KLYH, and assumes a departure from Frederick (Mary-
land) Municipal Airport, KFDK. The steps required to
set up and fly the approach are detailed below:



DO NOT USE FOR
NAVIGATION