Enabling Autopilot Outputs For The King Kap140/Kfc225 - Garmin GNS 530AW Pilot's Manual & Reference

5 - PROCEDURES
Enabling Autopilot Outputs
Enabling Autopilot Outputs for the King
KAP140/KFC225
Autopilot outputs for the King KAP140/KFC225
autopilots are activated manually by the pilot after being
prompted during the approach procedure. After enabling
outputs, the 500W-series unit will provide guidance
information consistent with what the autopilot expects
(i.e., angular CDI scaling and glideslope capture for an
LPV or other vertically guided GPS approach).
Conditions for autopilot outputs
1. The 500W-series unit must be configured during
installation to interface with these autopilots and
using "Prompt" for GPS Select.
2. Guidance to the FAF is active as indicated by Approach
mode annunciation (LNAV, LNAV+V, L/VNAV, or LPV).
To enable autopilot outputs
1. Load and activate approach information as
usual.
2. When you are turned on course to the FAF (Track
and Desired Track are within 10°), a message
will prompt you to enable the autopilot outputs
before using your autopilot for an approach.
3. Press PROC. Highlight "Enable A/P APR Out-
puts?" with the large right knob, if necessary,
and press ENT.
120
4. Press the Approach button on the autopilot to
switch it to Approach mode. Your autopilot will
now use guidance from the 500W-series unit
for the approach.
190-00357-00 Rev G